1937 FORD (all Henry Ford steel)! all Ford powered! 289 v-8 and Tremec 5 speed
Private seller / Contact Seller
Hico, West Virginia, United States
Technical data for 1937 Ford street rod 2 door sedan
|Trim:||2 door sedan|
|Transmission:||Tremec 3650 5 speed|
|Drive type:||9'' Ford|
THIS IS A "DRIVER" YOU ARE GOING TO SEE A LITTLE DIRT, GREASE AND RESIDUE WHERE THIS OLE GAL HAS BEEN HAVING A LITTLE FUN!!!! NOT A TRAILER QUEEN..
1937 2 door sedan street rod - custom build!!!all ford - all steel- all ford drive line!!!!
- vintage air and heat-compac gen II heat cool defrost
- painless wiring
- holley 4 bbl
- aluminum performance radiator
- vintage air and heat condenser
- sanden compressor
- ididit column
- stewart warner gages
- mighty wipers
- stainless fuel tank
- upgraded fuse panel
- hazard flashers
- dome lamps
- centerforce clutch kit!
- Lakewood bellhousing
- tremec 5 speed
- hurst shifter
- center console
- storage under seat
- cup holders
- both seats fold forward for entrance and egress
- mustang II front end with rack and pinion steering
- Carrera coil over performance shocks
- full length exhaust
- aluminum intake
- electronic ignition
- centerline wheels
- ta radial tires
- gel battery
- battery box
- new trunk hinges
- ALL NEW GLASS AND ALL NEW RUBBERS!!!
- new felts in window tracks
- tubular a arms
- disc brakes on front
- all new brake and fuel lines
- 2 inch dropped spindles
- FORD 9 INCH, REBUILT- HAVE PICTURES
- RATIO OF REAR APROX 3.5
- rebuilt by driveline service of va
- lots of chrome on motor and lots of billet inside
I have many many receipts and invoices, put together in a very nice binder notebook with some pictures of the build.
lots of notes
its one thing to build a car but for someone to take the time to document it and what was used, takes that little extra effort
the floor of car is nice. the frame has been boxed, and the tremec was just recently swapped into the car and we removed a toploader at 60 the engine is running 1800 rpm.
I have more pictures and will be happy to put car on the rack and let you inspect it before you bid.
I have a local shipper that I can get a quote from when that time comes ITS ABOUT 1.25 A MILE GIVE OR TAKE DEPENDING ON LOGISTICS AND TIME FRAME
my phone is : Pat at 304 719 2657 thanks!!On Nov-23-19 at 14:56:50 PST, seller added the following information:
The engine side panels were sold by the last owner before I purchased the car. I saw on ebay where he had sold them.. I think there was an ac line that was in the way on the rh side causing it not to fit well and he wanted to show off the motor. If someone wants the side panels, they are on ebay for about 5 or 600 and I own a body shop,, I would do the painting and fitting of them if you purchased them . I will even pay half if that helps and the car meets reserve or gets a decent offer,,,I recently bought a 32 Ford and this car needs a new home.The Tremec was installed by me,, if you go and buy one and do the steel bellhousing and all, you will have 2 or 3 thousand in the install and the parts... I removed a top loader and my friend and I had a swap of trannys,, the tremec is much smoother and better on gas,, does not run the motor as hard at highway speeds.On Nov-23-19 at 15:50:01 PST, seller added the following information:
the windshield cranks out and has a new gasket too, forgot to mention that,, it goes wayyyyyyyyyyout!!!
I would also entertain a trade of half of the buy it now and the balance in payment form, in case you have something to trade, please send pictures to my number or thru the ebay message portal
the running boards may be fiberglass. The main body, doors, hood, trunk and fenders are all original Ford metal!!